Mitsubishi Electric AJ65SBT2B-64DA User Manual page 24

No. Name
PW LED
RUN
LED
Operation
1
status
display LED
L RUN
LED
L ERR.
LED
V
Offset/gain I
adjusting CH
2
LEDs OFFSET
GAIN
SELECT/
Used to make offset/gain setting in the test mode.
3
SET switch
UP/DOWN Used to adjust the offset value and gain value of the channel specified by
4
switch the SELECT/SET switch.
Table 3.1 Part names
On: Power supply on
Off: Power supply off
On: Normal operation
Flashing: 0.1s intervals indicate an output range
setting error.
Normal 0.5s intervals indicate a digital value setting
mode error.
Off: Indicates that 24V DC power supply
interrupted, watchdog timer error occurred,
write error for flash memory occured.
On: Indicate that the SELECT/SET switch is in
the SET position.
Test Flashing: FIndicates that making offset/gain setting
mode was attempted outside the setting range.
Off: Indicates that the SELECT/SET switch is in
the SELECT or center position.
On: Normal communication
Off: Communication cutoff (time expiration error)
On:
Flicker at fixed intervals:
Flicker at unfixed intervals:
Off :
Normal
Normally OFF.
mode
Test The LEDs lit change every time the SELECT/SET
mode switch is moved to SELECT.
7
Description
Indicates that station number setting
is outside the range.
Indicates that station number setting
was changed from that at power-on.
Indicates that you forgot fitting the
terminating resistor or the module or
CC-Link dedicated cable is affected
by noise.
Indicates normal communications.