Trimming Beard - Panasonic ER-GB70 Operating Instructions Manual

Trimming beard

Do not use with shaving foam applied or when the beard is
wet. A wet beard may stick to the skin or bunch up, making it
difficult to trim.
Adjusting the beard length
Make sure that the trimmer is
turned off.
1. Attach the comb attachment
for beard to the main body.
(See page 10.)
2. Set the trimming height.
3. Holding the trimmer with the
power switch facing upward,
trim by bringing the blade
in contact with the skin and
moving the trimmer against
the flow of the beard.
Hair trimmings may collect
inside the attachment when a
large volume of beard is cut, so
discard hair trimmings after each
use.
PB013791 - ER-GB70 _01EN_07-22-16.indd 11
Trimming without the comb attachment/
trimming the downy hair
1. Remove the comb
attachment.
2. Holding the trimmer with
the power switch facing
outwards, trim by bringing
the blade in contact with the
skin.
The trimmer cannot trim hair to
lengths less than 0.5 mm (1/64˝).
Beard shaping
Use the trimmer without any comb attachments to properly
shape your beard.
Use the precision trimmer for trimming narrow areas and for
detailed trimming. (See page 12.)
Above and below lips
Holding the trimmer with the power switch at the bottom, cut
across a line with the blade at a 90° angle to the skin.
11
2016/7/22 17:16:00