HP 10500 Series Configuration Manual page 60

Configuration procedure
1. Configure the RADIUS server (when the server runs on IMC PLAT 5.0):
NOTE:
This section assumes that the RADIUS server runs on IMC PLAT 5.0 (E0101H03) and IMC UAM 5.0 SP1
(E0101P03).
# Add the switch to the IMC Platform as an access device.
Log in to IMC, click the Service tab, and select User Access Manager > Access Device
Management > Access Device from the navigation tree. Then, click Add to configure an access
device as follows:
a. Set the shared key for secure authentication and accounting communication to expert.
b. Set the ports for authentication and accounting to 1812 and 1813, respectively.
c. Select Device Management Service as the service type.
d. Select HP(General) as the access device type.
e. Select the access device from the device list, or manually add the device with the IP address
10.1.1.2.
f. Click OK.
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the switch, which is chosen in the following order on the switch:
The IP address specified with the nas-ip command.
•
The IP address specified with the radius nas-ip command.
•
• The IP address of the outbound interface (the default).
Figure 13 Adding the switch as an access device
# Add a user for device management.
From the navigation tree, click the User tab, and select Access User View > Device Mgmt User.
Then, click Add to configure a device management user as follows:
a. Add a user named hello@bbb and specify the password.
50