PICTORIAL DIAGRAM 1.2. NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical compo- nent or electrical enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
3. Fasten the lower plate by pushing the two (2) latches out- 3.2.2. Installation ward. 1. Loop new belt (Panasonic Type UB8 only) around motor NOTE: For general servicing, it is necessary to eliminate shaft and agitator pulley; see illustration for correct belt pinching of any wire during reassembly. After servicing routing.
3.3. Agitator Assembly 3.4. Carpet/Bare Floor and Handle Replacement Release Assembly 3.3.1. Removal 3.4.1. Removal 1. The brushes are replaceable separately. When the 1. Place the carpet/bare floor pedal in the carpet position. brushes need replacing, the agitator assembly will have Insert a screwdriver under the back of the pedal cover to be removed.
according to the respective instructions. 6. Push each brush out of the agitator. 3.5. BRUSH REPLACEMENT 1. The agitator brushes should be replaced when the brushes are worn. Brushes should be checked by holding a card across the lower plate. If the bristles on the agitator assembly do not touch the card you should replace all the brushes for best cleaning results.
3.7. Power Cord / On-Off Switch 2. For switch replacement only, insert the new ON/OFF switch with the numbers 1,2,3, facing toward you, into the Replacement dust compartment until secured by the retaining tabs. Use a wire tie in the location illustrated taking care not to over- 3.7.1.
3.8. Thermal Overload 3.9.2. Installation 1. Place the motor back into the dust compartment with Replacement brushes aligned parallel to the front edge of the dust com- partment. 3.8.1. Removal 2. Rewire per the Pictorial Diagram. 1. Remove motor, as shown in motor replacement section. 3.