Transmitter Rf Troubleshooting Procedures - Nokia 3155 Rf Description And Troubleshooting

3155/3155i (RM-41), 3152 (RM-61)
RF Description and Troubleshooting
14. Click Read Phone to update the values.

Transmitter RF Troubleshooting Procedures

After Phoenix is set up using either the AMPS, Cell, or PCS setup procedures, use the
following steps to troubleshoot the transmitter.
1. Using a voltmeter, check to see that all VIO, VR2, VR6, and VR1B are on the
transmit system. (See
• If any are missing, look for SMD problems around the N7000 and the UEME.
• If SMD is good, replace the UEME.
2. Once all DC voltages are present, check the AGC control voltages. (See
Setup" on page 13,
• If the voltages are incorrect, check the SMD around TX_AGC1.
• If the SMDs are correct, replace the D2800.
3. Using an oscilloscope, check the input modulation BBIQ wave forms at R7021,
R7022, R7023, and R7024. They should all be present with an AC swing of about
500mVpp, with an offset of +1.2V.
• If one or more waveforms are missing, look for SMD problems around these
resistors.
• If the SMD is good, replace the UEM.
Page 20
Figure 14: RF PDM Control dialog box for PCS band
"Tx DC Test Points - Bottom
"Cell Tx Setup" on page 16, or
©2005 Nokia Corporation
Side" on page 23.)
"PCS Setup" on page 18.)
Company Confidential
"AMPS Tx
ISSUE 1 07/2005