I.link Messages; Usb Interface; Hdmi - Pioneer 7.1 VSX-AX2AV-S Operating Instructions Manual

Additional information
12
Symptom
You can't get i.LINK to display
when using the SIGNAL SELECT
button.
After upgrading a component, it
is not recognized and cannot be
selected using the i.LINK
connection.

i.LINK messages

You may see the following messages displayed in the front panel display when using the i.LINK interface.
Message
BUS FULL
CANNOT LINK 1
CANNOT LINK 2
LINK CHECK
LOOP CONNECT
NO NAME
NO SIGNAL
PQLS OFF
PQLS ON
UNKNOWN

USB interface

Symptom
No sound.

HDMI

Symptom
The HDMI indicator blinks
continuously.
No picture or sound.
78
En
Remedy
• Make sure your i.LINK source components are switched on.
• Check that i.LINK is assigned correctly (see The Input Setup menu on page 60).
• You may need to reset the i.LINK database memory in the receiver (use the front panel):
With the receiver in standby, press
CLEAR? appear in the display, press ENTER, then SETUP again to confirm. When you've reset the i.LINK
database memory, DB CLEAR SET shows in the display. If DB ERROR is displayed, step through the
procedure again.
Explanation
The i.LINK bus has reached its capacity and cannot transmit any more data.
The connection between the receiver and the selected i.LINK-equipped component is unstable. If the
i.LINK cables appear to be connected properly and both the receiver and i.LINK-equipped component are
on, switch both units off, then on again to re-establish the connection between them.
The receiver can't identify the selected i.LINK-equipped component. For example, the receiver may not be
able to identify an i.LINK-equipped personal computer.
The receiver is checking the i.LINK network. It does this when components are added to, or removed from
the network. The sound may be interrupted if this happens during playback.
The i.LINK network cannot function because the connected components form a loop. See Creating an
i.LINK network on page 50 for more on this.
When an i.LINK-equipped component has no name, this message is displayed instead of the proper
component name.
A component is outputting an i.LINK signal that the receiver cannot reproduce. This receiver can only
reproduce signals from i.LINK-Audio-equipped components. See About i.LINK on page 49 for more on this.
This is displayed on a playback component when PQLS turns off during playback. The sound may be
interrupted momentarily when this happens.
This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Remedy
• Make sure you have set up your computer system to output through the USB interface (see Using the USB
interface on page 51).
• Make sure your computers output level is turned up.
• Update to a more recent version of your software, try a different audio program, or try a different source.
Remedy
• Check all the points below.
• This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
compatible. If they are not, please connect them using the component, S-video or composite video jacks.
• Depending on the connected source component, it's possible that it will not work with this receiver (even
if it is HDCP-compatible). In this case, connect using the component, S-video or composit video jacks
between source and receiver.
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
STANDBY/ON while holding down RETURN. When you see DB