JVC UX-G300B Service Manual page 15

Table of Contents

Advertisement

3.2.3 Removing the traverse mechanism assembly
(See Fig.4)
(1) Remove the four screws C attaching the traverse mecha-
nism assembly from bottom side of CD mechanism assem-
bly.
(2) Disconnect the card wire from connector
servo board and then take out the traverse mechanism as-
sembly and CD servo board together.
Reference:
When reattaching the traverse mechanism assembly, the card
wire should through the part d.
CN602
of the CD
CD mechanism assembly
CD servo board
Card wire
d
C
Traverse mechanism assembly
Fig.4
(No.MB665<Rev.004>)1-15
C
CN602

Advertisement

Table of Contents
loading

Table of Contents