Removing The Cd Mechanism Assembly - JVC RC-BZ5LB Service Manual

RC-BZ5LB/BZ5RD
RC-BZ6BU
Removing the
assembly (See Fig.13 to 15)
Prior to performing the following procedure, remove
the CD / cassette and amplifier assembly, the CD
cover and door unit and disconnect the harnesses
connected to the key switch / display board.
The cassette mechanism cover is still attached.
1. Push inward the locking tabs e on both sides of the
cassette mechanism cover and remove the
mechanism cover in the direction of the arrow.
2. Disconnect the harnesses from connector CN301
and CN308 on the main board.
3. Remove the upper two screws F and the cassette
mechanism assembly toward the front.

Removing the CD mechanism assembly

Prior to performing the following procedure, remove
the CD / cassette and amplifier assembly, the CD
cover and door unit.
1. Disconnect the harness from connector P011 on the
motor board in the lower part of the CD mechanism
assembly. Then disconnect the pickup card wire
from CN601 on the main board.
2. Remove the CD mechanism assembly upward.
Motor board
P011
Main board
CN601
1-10
cassette mechanism
(See Fig.16)
CD mechanism assembly
Fig.16
Cassette mechanism assembly
Locking tab e
Cassette mechanism cover
CN301
F
Cassette mechanism assembly
Locking tab e
Cassette mechanism
Fig.13
Cassette mechanism assembly
Fig.14
Main board
CN308
F
Fig.15
cover