Nokia Customer Care
Switching the Rx Gain States
Use the RF Gen I/O dialog box to switch the gain state (Hi and Lo) for CDMA and AMPS
modes.
High Gain State (default)
Low Gain State
Checking AMPS from RF to IQ
Use the following steps to check the AMPS receiver functionality from RF to IQ output.
1. Start Phoenix in Local Mode with only the Rx path turned on.
2. Inject a –75dBm CW signal of 881.53MHz (i.e. 10kHz offset from 881.52MHz)
into the RF.
3. Measure a 10kHz tone on the analyzer. You should see a typical -20Bm IQ tone
for AMPS.
Issue 1 04/2005
Figure 30: RF Gen I/O dialog box
©2005 Nokia Corporation
6235/6235i/6236i (RM-60)
RF Description and Troubleshooting
Cell
AMPS
PCS
CDMA
Company Confidential
Page 33