6235/6235i/6236i (RM-60)
RF Description and Troubleshooting
Figure 32
shows the AMPS spectrum and the test points located on the top side of the
main PWB. All four test points should be approximately equal. WARNING: Direct current
is present on these test points.
Figure 32: AMPS spectrum and the test points on the top side of the main PWB
Checking Cell Receiver from RF to IQ
Use the following values to check the Cell receiver functionality RF to IQ output.
1. Start Phoenix in Local Mode with only the Rx path turned on.
2. Inject a –75dBm CW signal of 881.82MHz (i.e. 300kHz offset from 881.52MHz or
10 channels away).
Page 34
Figure 31: Receiver IQ Level on AMPS band
©2005 Nokia Corporation
Rx_IP
Rx_IN
Company Confidential
Rx_QP
Rx_QN
Issue 1 04/2005