Installation - LG LST-280T User Manual

Introduction
2.3 3 LED Indicators
I I n n f f o o r r m m a a t t i i o o n n A A c c t t i i v v i i t t y y
Green
Service Yellow
Red(Blink)
PWR (AC/Batt) Red(Solid)
Mode Green(Blink)
Over charger
Red(Fast Blink)
warning
12
M M e e a a n n i i n n g g
Good signal strength
Poor signal strength
No service Area
Low Battery (Only battery mode)
Alarm alert, Incoming ringing
Over voltage charger connected
< Table 1 >

2.4 Installation

You should follow each step carefully as shown below
in order to guarantee proper operation of CDMA
Fixed Wireless Telephone.
STEP I. Check Components
▶
Fixed Wireless Terminal is supplied with the
following standard unit and accessories:
1. LST-280T Unit -1EA-
2. Dipole Antenna -1EA-
3. Backup Battery -1EA-
4. User Guide -1EA-
5. AC/DC Power Adapter -1EA-
▶
Please make sure that these components are
present and check for evidence of shipping before
you begin the unit installation.
▶
If components are missing or damage is found,
contact your authorized LGE Service Center
immediately.
Introduction
STEP II. Place the Terminal
▶
Place the terminal on the stable flat secure surface
area (desk, table, etc.).
Avoid direct exposure to the sunlight and damp
areas.
▶
Read the SAFETY INFORMATION located at the
first part of this document before you place the
terminal.
STEP III. Connect Components
▶
Connect the Dipole antenna to the TNC connector
located at the topside of the terminal. (See Figure 1
to locate the TNC connector.)
If you have placed the terminal on the flat surface,
position the antenna up side.
▶
Connect your phone cord to the RJ-11 port located
at the side of the terminal.
▶
Connect the battery cable to the DC battery
connector at the side of the terminal.
- Remove the battery compartment cover.
13