Table of Contents
Advertisement
FIXING THE COOKTOP
Each cooktop is supplied with a set of tabs and screws to fasten it on units with a working
surface from 3 to 5 cm deep .
The kit includes 4 tabs "A" and 4 self-threading screws "B" (figs. 4.4, 4.4a, 4.4b).
•
Cut the unit .
•
Turn the hob upside down and rest the glass side on a cloth .
•
Spread the sealing material "C" around the edge of the hob .
•
Put tabs "A" into the mountings by using the screws "B" (only tighten screws a few
turns) .
Make sure that the tabs are mounted correctly as shown in the figure 4.4a or 4.4b
(depending on the thickness of the cooktop surface) .
•
Put the cooktop into the hole cut into the unit and position it correctly .
•
Put tabs "A" into place . Tighten screws "B" until the cooktop is completely secured .
•
Using a sharp tool cut off the part of gasket "C" which protrudes from the cooktop . Take
care not to damage the workbench .
C
Adhesive side
IMPORTANT: Spread the sealing material "C" around
the edge of the hob.
The sealing material "C" must be installed correctly
to guarantee a perfect seal between the appliance and
the unit. Incorrect installation may cause irreparable
damage to the appliance.
28
Cooktop surface
30 mm thick
C
B
A
Fig. 4.4a
Cooktop surface
40 to 50 mm thick
C
B
A
Fig. 4.4b
Fig. 4.4
Hide quick links:
Advertisement
Table of Contents
