Section 3: Programming The Communicator; General Information; Using The Alarmnet Direct Website; Using A 7720P Programming Tool - Honeywell GSMV4G Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

General Information

The communicator is designed to deliver alarms via the GSM network to an AlarmNet
central station when it is registered with a valid AlarmNet account.
The communicator requires an AlarmNet–i account. For new installations, please obtain the account
information from the central station prior to programming this communicator. For replacement
installations, the AlarmNet-i account is created automatically when the communicator is registered.
You can program the communicator by one of the following methods:
• Through the AlarmNet Direct website
• Through use of a 7720P Programming Tool
• Through a programming mode in the control panel on panels that support this option
(e.g., VISTA-128BP and FBP)
UL

Using the AlarmNet Direct Website

To program the communicator via the website (if you are already signed up for this service),
go to:
https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx
If you are not signed up for this service, click on "Dealer Sign-Up."
Log in and follow the on-screen prompts.
Please have the following information available when programming the communicator:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on the box and inside the communicator)
After programming is complete, you must transfer the data to the communicator and the
communicator must be registered. Refer to Section 4: Registration, for further instructions.

Using a 7720P Programming Tool

Connect the 7720P Programming Tool as shown below. The communicator powers the 7720P
Programming Tool via the programming jack, and automatically senses the presence of the
7720P when it is plugged in.
Programming the Communicator
Only ECP and Zone Trigger modes have been evaluated by UL.
S E C T I O N 3
3-1