Siemens RUGGEDCOM RX5000 Installation Manual page 31

RUGGEDCOM RX5000
Installation Guide
Figure 14: Removing a Module
1. Chassis 2. Module 3. Screw
5. Install a new module or a blank module (to prevent the ingress of dust and dirt).
6. [Optional] If necessary, install the device in the rack.
7. Connect power to the device.
Installing a Line Module
To install a line module, do the following:
1. Make sure power to the device has been disconnected and wait approximately two minutes for any remaining
energy to dissipate.
2. [Optional] If the device is installed in a rack, remove it from the rack.
3. Remove the current module from the slot.
4. Insert the new module into the slot.
Installing/Removing Line Modules
1
2
3
Chapter 3
Modules
23