Section 3 - Operator Messages; Fault Finding And User Repair; Operator Messages - ABB 800xA Operation

For safeguard

Hide thumbs Also See for 800xA:

Table of Contents

For details on fault finding and error messages, refer to Industrial

800xA for Advant Master, Configuration (3BSE030340*).

If incorrect parameters are specified, or if other communication problems occur, an

operator message is issued. The message is included in the event list. The event list

must be of type 'Operator Messages List' set up at the time of system configuration.

The following additional operational messages specific to Safeguard 400 Series

controllers apply.

Dual: Command executed in one of the dual nodes only

The command given from the operator station has only been executed by one of the

controllers in the Safeguard system. Check if both controllers are available on the

network or if one of them is in configuration mode.

Dual: Command not executed. Nodes currently not available

The command given from the operator station has not been executed by any of the

controllers in the Safeguard system. Try to give the command once more, if no

improvement, check whether the controllers are overloaded.

3BNP004849-600

Section 3 Operator Messages

800xA, System,

Table of Contents