Care And Cleaning; Specifications; Helpful Hints - Sanyo CP14SE1 Instruction Manual

Care and Cleaning / Specifications / Helpful Hints

Care and Cleaning

The surface of the cabinet can be damaged if not properly maintained. Many common household aerosol sprays, clean-
ing agents, solvents and polishes will cause permanent damage to the fine surface.
1. Unplug the power cord before cleaning the Television.
2. Clean the screen with a soft cloth dampened with glass cleaner or warm water.
3. Clean the cabinet with a soft cloth dampened with a mild household detergent and warm water. Dry
thoroughly.
Note: NEVER spray liquids on the screen because they can run down and drip onto the chassis. This may cause com-
ponent failure not covered under Warranty.

Specifications

AC220-240 Volts, 50/60Hz
Power Source
PAL/NTSC4.43/NTSC/PAL-60Hz
Colour System
B/G, I, D/KK', M/M
Sound System
Channel Coverage
VHF: E2-E12, A2-A13, R1-R12, J1-J12, K1-K9
0-11, 5A (AUS), 1-11 (NZ)
UHF: 21-69, A14-A69, J13-J62,
28-69 (AUS)
CATV: S1-S41, X, Y, Z, Z+1, Z+2
Aerial input impedance
Audio output (RMS) : 5 W + 5 W (All Models)
Speakers : 5 x 9 cm x 2 pcs (All Models)

Helpful Hints

NO PICTURE, NO SOUND
Check if TV is plugged in.
Try a different channel, if OK, probably station trouble.
POOR PICTURE, SOUND OK
Adjust BRIGHTNESS control.
Adjust FINE TUNING control.
Check aerial connections
NO COLOUR, PICTURE OK
Adjust COLOUR control.
Adjust FINE TUNING control.
Is the programme in colour ?
WEAK PICTURE
Check aerial connections on back of set.
Check aerial for broken wires.
Re-orient aerial.
10
75 Ω
Ext. terminals
DVD Video Component: Composite/Component Y,
CB,CR input (Optional Models)
Video inputs: Phone Jack x 2 (1.0Vp-p, impedance 75Ω)
Audio inputs: Phone Jack x 2 (436mVrms, impedance
more than 40KΩ)
Video monitor outputs: Phone Jack x 1 (1.0Vp-p,
impedance 75 Ω)
Audio monitor outputs: Phone Jack x 1 (436mVrms,
impedance less than 600Ω)
Dimension
Model CP14SE1, CA14SE1:
433 (W) x 336 (H) x 353 (D)mm
Model CP21SE1, CA21SE1:
580 (W) x 460 (H) x 457 (D)mm
Weight
Model CP14SE1, CA14SE1: approx. 8.7 Kg
Model CP21SE1, CA21SE1: approx. 18.7 Kg
Specifications subject to change without notice.
The following faults are not caused by the
receiver:
"GHOSTS"
Reflections of signals from mountains or high build-
ings will cause multiple images, called "Ghosts".
These abnormal conditions can be reduced to mini-
mum by repositioning aerial or by installing a new one
suited for your area.
"INTERFERENCE"
Interference may be caused by electrical appliances,
car ignition systems, etc. This should normally be a
temporary condition, but should this interference per-
sist, contact your dealer.