Engine Starting; Pre-Start Checks - Yamaha RMAX Type II G Unit Operation Manual

Flying Procedure

Engine Starting

Pre-start Checks

1 Check that the flight mode selector switch on the
helicopter is set to the position that you have
selected.
• To use the A or AG mode, turn the switch to
"A".
• To use the C or CG mode, turn the switch to
"C".
• To use the S or SG mode, turn the switch to
"S".
See page 4-13 for a detailed description of the flight
modes.
2 Check that the sprayer selector switch is set to
the position of the sprayer that you will be using.
• When using the liquid sprayer, turn the switch
to " " or "
3 Extend the antenna of the transmitter and turn
the power switch ON.
• Check the battery level (the buzzer should
beep a minimum of 3 times).
• Check that the YACS control switch is ON and
the GPS control switch is OFF.
4 Turn the main switch on the helicopter to START.
• Check that all the lights on the self monitor illu-
minate for 2 seconds.
• Check all of the lights of the temperature sen-
sor monitoring LED.
Currently, the
exported.
5-3
".
TIP
granular sprayer is not
4 1 2