Table of Contents
Advertisement
3. TURNING ON/OFF POWER
3.1 Turning On Power
To turn on power of the Gateway, follow the procedure below.
Failure to follow the following instructions result in fire or electric shock.
Do not use any other AC adapter for the Gateway than the one attached to the
Gateway.
Do not use the AC adapter attached to the Gateway for any other device.
Do not use any other power cord for the Gateway than the one attached to the
Gateway.
Do not use the power cord attached to the Gateway for any other device.
At power-on, all lamps in the front access area temporarily turn on.
1.
(First time only) Insert the DC IN 12V jack of the attached AC adapter fully into the
mating port in the rear access area of the Gateway (see Section 1.2 for the port
location). When performing this insertion on the Gateway mounted on the wall,
support the Gateway by hand to avoid extra mass. Keep this connection
throughout use of the Gateway.
2.
(First time only) Connect the cord connector of the attached power cord fully into
the slot in the AC adapter if they are not yet connected. Keep this connection
throughout use of the Gateway.
3.
While holding the plug case of the power cord by hand, plug the power cord fully into
the outlet. This action automatically turns on power of the Gateway. Ensure that
all lamps in the front access area temporarily turn on at power-on.
3.2 Turning Off Power
To turn off power of the Gateway, unplug the power cord from the outlet while holding
the plug case of the power cord.
While firmware upgrade is in progress, do not disconnect power until installation of a
new firmware version is finished. Otherwise, firmware upgrade will not complete
successfully.
WARNING
INFORMATION
INFORMATION
- 12 -
Advertisement
Table of Contents
