Connection By Directly Typing Ssid On Mac Os® X - Hitachi EM-G21 User Manual

5.5.2 Connection by Directly Typing SSID on Mac OS® X
1. If you have not turned on the Gateway and/or the user PC, first start up the Gateway
and then start up the user PC.
2. Disconnect the LAN cable if connected between the user PC and the Gateway.
3. On the user PC, click Apple menu and select System Preferences... in the menu.
4. Click Network icon.
5. In the "Network" dialog opened, click AirPort in the left pane, select Automatic in
"Location" field, and click Advanced... button.
6. In the "AirPort" dialog opened, click AirPort tab and click + button below the list of
"Preferred Networks" section.
7. In "Network Name" field, type the SSID value you determined in Subsection 5.1.1
(emg21-●●●●●●-1 for SSID-1 and emg21-●●●●●●-2 for SSID-2 where ●●●●●●
depends on the actual unit).
8. In "Security" field, select an option according to your preference. WPA2 Personal
is recommended for an IEEE 802.11n-based user PC.
9. In "Password" field, type the Security Encryption Key value you determined in
Subsection 5.1.2. Click Add button.
10. Ensure that the specified SSID appears in the list of "Preferred Networks" section.
Click OK button to close the "AirPort" dialog.
11. In the "Network" dialog returned, select the specified SSID in "Location" field and
click Advanced... button again.
12. In the "AirPort" dialog opened, click TCP/IP tab.
13. In "Configure IPv4" field, select Using DHCP. In "IPv4 Address" field, ensure that
an IP address is shown. Click OK button to close the "AirPort" dialog.
14. In the "Network" dialog returned, click Apply button to close the dialog. When
done, exit System Preferences.
Note: If you encounter a connection error dialog during the procedure above,
specifying of a wrong parameter or value is suspect. Click OK button in the error dialog
and redo Steps 3 through 14.
- 24 -