Bosch GWH-635-ES User Manual page 4

Using the Remote Control
4.2 Remote control trans-
ceiver PCB installation
Warning:
safety
disconnect
power supply to the
heater.
Pre-installation preparation
B Remove the plug from the supply
socket.
B Remove plastic decals on front
panel.
B Undo two Philips head screws
located behind decals.
B Lift front cover panel upward and
remove.
B Remove the lower cover from the
control box.
B Remove the 2 sets of cables from
the control box PCB.
B Undo connections from both ignition
cables.
B Remove holding bracket.
B Remove control box.
Control box is now out of the appliance
casing.
4
For
reasons,
the
Remote control transceiver PCB
installation
B Open control box top cover (Fig. 3,
pos. 1).
B Remove the protective cover (Fig. 3,
pos. 2) from one face of the support
and fix it to the main PCB as shown
in Fig. 3.
Fig. 3
B Remove the other protective cover
and fix the remote control PCB as
shown in Fig. 4.
Assure that the face of the remote
control PCB is against the control box.
6 720 606 990