Table of Contents
Advertisement
WIT-300H Installation Manual
Issue: 0.1C
2.2.1
SSID
SSID is for authentication use. An AP can have an arbitrary SSID value for example "wireless". In this
case, WIT-300H with "wireless" SSID can communicate with that AP. It is important to use accurate SSID
on both WIT-300H and AP.
Recommendation)
(1) If you are free of security, please just use one SSID for all APs and WIT-300H.
(2) If you are using WIT-300H in a wireless environment with predetermined SSID, please
change the SSID of your WIT-300H.
After changing the SSID of WIT-300H, you need to reboot it to apply the change.
2.2.2
DTIM (Data Traffic Indication Map) & Beacon
DTIM is related to an interval of packet transmission. By an inherent nature of the iPECS LIK-300, WIT-
300H frequently uses multicast message for the communication with the iPECS LIK-300. The delivery of
multicast message is affected by the DTIM parameter.
Beacon is an indication of packets buffered in AP which are to be delivered to each wireless station, WIT-
300H. The information of DTIM is contained in a beacon message. Therefore, DTIM configuration can be
affected by the beacon interval. The following is illustrating the relationship of beacon and DTIM:
Recommendation)
(1) DTIM should be less than 200 msec.
(2) If AP doesn't support DTIM configuration, more special care needs to be taken for Beacon
interval setup. Otherwise, Use the smallest DTIM interval that AP can support.
2.2.3
Configuration
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of LG Electronics company
14
Date:: 30/Jan/05
Advertisement
Table of Contents
