Igmp Host-Tracking; Igmp Last-Member-Query-Interval - HP 3600 v2 Series Command Reference Manual

You can also use the group-policy (IGMP-snooping view) command to control the multicast groups that
hosts in a VLAN can join, achieving the same result as igmp group-policy. If you have configured a
multicast group filter on a VLAN interface to control the multicast groups that the hosts on the interface
can join, HP recommends you to configure the same multicast group filter in the corresponding VLAN.
Related commands: group-policy (IGMP-snooping view).
Examples
# Configure an ACL rule so that hosts on VLAN-interface 100 can join multicast group 225.1.1.1 only.
<Sysname> system-view
[Sysname] acl number 2005
[Sysname-acl-basic-2005] rule permit source 225.1.1.1 0
[Sysname-acl-basic-2005] quit
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp group-policy 2005

igmp host-tracking

Syntax
igmp host-tracking
undo igmp host-tracking
View
Interface view
Default level
2: System level
Parameters
None
Description
Use igmp host-tracking to enable the IGMP host tracking function on an interface.
Use undo igmp host-tracking to disable the IGMP host tracking function on an interface
By default, this function is disabled.
Related commands: host-tracking.
Examples
# Enable the IGMP host tracking function on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] igmp host-tracking

igmp last-member-query-interval

Syntax
igmp last-member-query-interval interval
undo igmp last-member-query-interval
92