To do...
Specify a RIP neighbor
Enter interface view
Enable BFD on the RIP interface
NOTE:
Unidirectional detection in BFD echo packet mode only works for RIP neighbors that are directly
•
connected (one hop away from each other).
•
Using the undo peer command does not remove the neighbor relationship at once; therefore, it cannot
bring down the BFD session at once.
Displaying and maintaining RIP
To do...
Display RIP current status and
configuration information
Display all active routes in RIP
database
Display RIP interface information
Display routing information about
a specified RIP process
Reset a RIP process
Clear the statistics of a RIP process
RIP configuration examples
Configuring RIP version
Network requirements
As shown in
Figure
10, enable RIPv2 on all interfaces on Switch A and Switch B.
Use the command...
peer ip-address
interface interface-type
interface-number
rip bfd enable
Use the command...
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
reset rip process-id process
reset rip process-id statistics
37
Remarks
Required
By default, RIP does not unicast
updates to any peer.
—
Required
Disabled by default
Remarks
Available in any view
Available in user view