Disabling Host Route Reception - HP 3600 v2 series Configuration Manual

Enabling RIPv2 route automatic summarization
You can disable RIPv2 route automatic summarization if you want to advertise all subnet routes.
Follow these steps to enable RIPv2 route automatic summarization:
To do...
Enter system view
Enter RIP view
Enable RIPv2 automatic route
summarization
Advertising a summary route
Follow these steps to configure RIPv2 to advertise a summary route on the specified interface:
To do...
Enter system view
Enter RIP view
Disable RIPv2 automatic route
summarization
Return to system view
Enter interface view
Advertise a summary route
NOTE:
You must disable RIPv2 route automatic summarization before advertising a summary route on an
interface.

Disabling host route reception

A router can receive many host routes from the same network, which is not helpful for routing and
consumes a large amount of network resources. You can disable RIP from receiving host routes to save
network resources.
Follow these steps to disable RIP from receiving host routes:
To do...
Enter system view
Enter RIP view
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
summary
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
undo summary
quit
interface interface-type
interface-number
rip summary-address ip-address
{ mask | mask-length }
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
28
Remarks
––
––
Optional
Enabled by default
If the subnet routes in the routing
table are not consecutive, disable
automatic route summarization to
avoid black hole routing.
Remarks
––
––
Required
Enabled by default
—
—
Required
Remarks
—
—