Deleting Ip Addresses; Advanced Ip Configuration - Hitachi 3080 Network Administration Manual

Procedure
1.
2.
3.
4.
5.

Deleting IP addresses

Caution: IP address deletion alert! Before following the instructions in this
procedure, ensure that the IP address is not in use. Active connections are
terminated on removal and clients can become unresponsive.
Procedure
1.
2.
3.
4.
5.
6.

Advanced IP configuration

To configure additional settings for IP addresses, navigate to Network
Configuration > Advanced IP Configuration.
50
Navigate to Home > Network Configuration > IP Addresses > add.
The Add IP Address page appears.
Select a Virtual Server (EVS) to assign to the IP address.
Select an aggregation or management interface:
• agX identifies one of the file serving aggregation interfaces
• eth-agX identifies one of the Aggregate Linux interfaces
• agX-vlanXXXX identifies one of the VLAN interfaces
• eth0 or eth1 identifies a 10/100/1000 interface for a Hitachi NAS
Platform
• mgmnt1 identifies the 10/100 management interface for a Hitachi
High performance NAS Platform
Note: When assigning an IP address to a file-serving EVS, the
Administrator must specify a link aggregation or VLAN interface.
Enter the IP address and Subnet Mask for the selected interface.
Verify the settings, then click OK to apply the settings or cancel to
decline.
Navigate to Server Settings > EVS Management.
Select the EVS to which the IP is assigned, then click disable.
Navigate to Network Configuration > IP Addresses.
Select the IP Address to delete, then click delete.
Navigate to Server Settings > EVS Management.
Select the EVS again and click enable to re-activate the EVS.
Configuring IP addresses
Hitachi NAS Platform Network Administration Guide