Panasonic PAN9420 Product Specification page 39


However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help
5.4.1.3 Label Requirements
This FCC identifier is valid for the PAN9420. The end product must in any case be labelled on
the exterior with:
"Contains FCC ID: T7V-9420".
5.4.1.4 Antenna Warning
This antenna warning refers to the test device with the model number ENW49C01A3KF in
bottom pad mode
The device is tested with a standard SMA connector and with the antenna listed below. When
integrated into the OEM's product, these fixed antennas require installation preventing end
users from replacing them with non-approved antennas. Any antenna not in the following table
must be tested to comply with FCC Section 15.203 for unique antenna connectors and with
Section 15.247 for emissions. The FCC identifier for the device with the antenna listed in
 5.4.1.5 Approved Antenna List
Product Specification Rev. 1.1
5 Cautions, Life Support Policy, RoHS Declaration, and Regulatory Information
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
The Original Equipment Manufacturer (OEM) must ensure that FCC labelling
requirements are met. This includes a clearly visible label (laser marking) on
the outside of the OEM enclosure specifying the appropriate Panasonic FCC
identifier for this product as well as the FCC Notice above.
The FCC identifier is FCC ID: T7V-9420 for model ENW49C01A3KF.
 Chapter 4.3.2 Module Selectable RF-In/Output.
is the same (FCC ID: T7V-9420).
PAN9420 Wi-Fi Module
Page 39