Advertisement
Installing an RTN 360
1
Installing an RTN 360 at the Edge of a Mobile Backhaul Network
Installation procedure
Install an RTN 360 on a pole or wall.
1
2
Install the ground cable.
Connect one end of an outdoor network cable to port
3
P&E on the RTN 360.
PoE supports a maximum distance of 100 meters.
Commissioning procedure
Align the RTN 360 with its peer.
4
Connect the other end of the outdoor network cable to port WAN on a Dock.
5
Traffic transmitted to the opposite wireless
equipment is forwarded by port LAN0 on the Dock.
Use clips to fix any indoor sections of the outdoor
network cables that connect to ports WAN and
LAN0 on the Dock.
Load commissioning data to the RTN 360 using the
6
Web LCT or USB flash drive.
Ensure that the received signal level (RSL) of
7
the RTN 360 meets the requirement.
8
Verify the installation.
08/09 >>
Optional: Install the
RTN 360 on a pole.
1
Optional: Install the
RTN 360 on a wall.
Dock
6
To the RTN 360
To the opposite wireless equipment
RTN 360
1
2
6
Clip
External power
supply equipment
Optional: In this example, port GE(e) is
not used. In practice, determine whether
to use this port based on your service
plan.
In this example, the RTN 360 uses port
P&E to receive services and power
signals.
3
Opposite wireless equipment
Advertisement
