Advertisement
Installing an RTN 360
2
Installing RTN 360s at 2x(1+0) Aggregation Sites
Installation procedure
Install two RTN 360s on a pole or wall.
1
2
Install their respective ground cables.
Connect an outdoor network cable to port P&E on each
3
RTN 360.
PoE supports a maximum distance of 100 meters.
Commissioning procedure
Align each RTN 360 with its peer.
4
Connect one of the two outdoor network cables to port WAN on
5
a Dock and the other to port LAN1 on the Dock.
Traffic transmitted to the opposite wireless
equipment is forwarded by port LAN0 on the Dock.
Use clips to fix any indoor sections of the outdoor
network cables that connect to ports WAN, LAN0,
and LAN1 on the Dock.
Load commissioning data to the RTN 360s using
6
the Web LCT or USB flash drive.
Ensure that the RSLs of the two RTN 360s meet
7
the requirements.
Verify the installation.
8
10/11 >>
Optional: In this example, port GE(e)
on neither RTN 360 is used. In practice,
determine whether to use this port
based on your service plan.
2
In this example, both RTN 360s use
their respective P&E ports to receive
services and power signals.
RTN 360
2
External power
supply equipment
RTN 360
1
Optional: Install the
RTN 360 on a pole.
3
1
Optional: Install the
RTN 360 on a wall.
6
6
3
Dock
Port WAN, which is connected to one RTN 360
Port LAN0, which is connected to the opposite wireless equipment
Port LAN1, which is connected to the other RTN 360
Opposite wireless equipment
Advertisement
