Canting The Camera - Bosch MIC-7502-Z30B Installation Manual

22 en | Mounting
Sunshield accessory
7.4

Canting the Camera

Note:
For simplicity, the graphics in this section are only of the camera (and the specific accessory
that you are installing, if applicable). The graphics do not depict other accessories that you
may have installed already.
MIC7000 / MIC IP starlight 7000i cameras have on-site canting functionality.
Installers can adjust the camera from an upright position to a canted position if desired. This
allows the camera to be installed at a 45º angle so that its field of view (FOV) can observe the
scene directly beneath the camera.
Note: Canting is not applicable when the camera is installed in inverted orientation.
Warning!
Risk of bodily injury.
!
Unplug the device from its power source before canting the device. After removing the screws
from the yoke arms, support the camera head so that it doesn't tilt downward unexpectedly
and pinch fingers or other body parts.
Notice!
Risk of damage to the camera
Do not, under any circumstances, cant the camera while the camera is on its side. Cant the
camera from an upright position only, in order to prevent screws or other objects from falling
into the open spaces in the arms when the yoke caps are removed.
2017.09 | 0.12 | F.01U.xxx.xxx
3.5 mm (≈ 1/8")
Installation Manual
MIC IP starlight 7000i
Bosch Security Systems