HP 9000 Installation Manual page 44

R Class Internal Peripherals Installation
Installation Procedures
L. Replace the
Refer to the figure on this page while performing these steps.
Memory SIMM
1. Position the memory SIMM retainer between the memory SIMMs and the HSC
Retainer
2. Lower the retainer until its bottom flange rests on the plastic HSC card
CAUTION
Avoid contact between the metal tabs at the foot of the retainer and the circuitry on
the system board beneath. Otherwise, damage to the system board may occur.
3. Pull the top of the retainer toward the memory SIMMS until the top rear flange
2-14
card slot, centered over the memory SIMMs.
connector just above the system board in the bottom of the chassis.
hooks behind the processor/memory board, and the small tabs next to the flange
rest on the top edge of the processor/memory board.