Messages - Yamaha MRX7-D Owner's Manual



Messages

Warnings and certain other types of information are displayed via the MRX7-D front panel indicators.
Messages are also displayed in the Dante Controller Error Status field.
Each indicator lights or flashes as described below:
Unlit The indicator is off.
Lit The indicator remains lit steadily.
Flash The indicator continues to flash.
Flash x 2 The indicator flashes twice cyclically.
NOTE
You can make settings in MTX-MRX Editor so that the [SYNC] indicator will remain unlit.

Information Messages
The status is shown by the lit/flashing state of the indicator.
If the orange [SYNC] indicator is unlit, the unit is operating normally.
If the green [SYNC] indicator is unlit, the unit's clock is unconfirmed.
SYNC Indicators
(green) Unlit
(orange) Lit
(green) Flash
(orange) Unlit
(green) Lit
(orange) Unlit

Warning Messages
The indicator will remain lit or continue flashing cyclically until the problem is solved.
If the green [SYNC] indicator is unlit, the unit's clock is unconfirmed.
SYNC Indicators
(green) Unlit
(orange) Flash
(green) Unlit
(orange) Flash x2
If the green indicator is flashing, the unit is the clock master.
If the green indicator is lit, the unit is the clock slave and the clock is synchronized.
SYNC Indicators
(green) Lit or flash
(orange) Lit
(green) Lit or flash
(orange) Flash
(green) Lit or flash
(orange) Flash x 2
Description
Synchronization is occurring.
The unit is functioning correctly as the word clock
master.
The unit is functioning correctly as the word clock
slave.
Description
The word clock is not set correctly.
Dante Network circuit is broken.
Description
A non-GbE-compatible device is connected.
The Dante [SECONDARY] connector has taken
over communications during redundant network
operation.
An abnormality has occurred on the circuit con-
nected to the Dante [SECONDARY] connector dur-
ing redundant network operation.
Explanation
Please wait until the unit synchronizes
completely. It may take approximately
60 seconds for synchronization to be
completed.
The unit is operating as the word clock
master.
The unit is operating as the clock slave
and the clock is synchronized.
Possible Solution
Set the clock master and sampling fre-
quency correctly on the MTX-MRX
Editor or in Dante Controller.
Make sure that the Ethernet cables are
not removed or short-circuited.
Possible Solution
When transferring audio via Dante, use
device that supports GbE.
Check the circuit connected to the
Dante [PRIMARY] connector.
Check the circuit connected to the
Dante [SECONDARY] connector.
MRX7-D Owner's Manual
Appendix
25