Yamaha MRX7-D Owner's Manual page 27

Alert
Meaning
number
A timeout has occurred in synchronization
44 to the time server or the server reply is
invalid.
The host name of the time server can not
45
be resolved by DNS server.
Dante transmission flow count exceeded
46
the limit.
50 The UNIT ID is set to "00."
Devices with identical UNIT IDs were
51 found connected within the same net-
work.
A communication error occurred with the
52
[DCP] connection.
The DCP connected to the [DCP] connec-
53 tor has been configured differently from
the project settings.
56 SD memory card was not recognized.
Unable to play the specified file or folder
58
in the SD player.
A preset/snapshot recall attempt has
60
failed.
The recall could not be executed because
61 the preset to be recalled when the device
starts up was not found.
The preset/snapshot could not be
64
recalled.
65 Invalid parameters are set for GPI IN.
66 Invalid parameters are set for GPI OUT.
67 Invalid parameters are set for DCP[*].
Invalid parameters are set for Wireless
68
DCP.
Synchronization has not been com-
70 pleted. It may be that synchronization was
halted before completion.
The UNIT ID settings when synchroniza-
71 tion was performed do not match the cur-
rent UNIT ID settings.
Because this device has Dante Device
Lock enabled, the settings of device DIP
72
switches and MTX-MRX Editor do not
match current Dante settings.
80 Speech Privacy Audio File is not installed. Install the Speech Privacy Audio File.
Check the time server condition or set another time server.
Check the setting of the time server, DNS server address or make sure that the
DNS server works correctly.
Maximum Dante Flow rate exceeded. Try changing parts of transmission flows to
Multicast using Dante Controller.
Set the UNIT ID to something other than "00."
Change the UNIT ID so that there are no duplicates.
• If an error was shown in the DCP panel, refer to the DCP owner's manual and
take the appropriate action.
• Ensure that the panel ID of the DCP units do not conflict.
• Verify that the cables are correctly connected and are within the specified length.
• Check that the required DCP is connected.
• Check whether a different model of DCP might be connected.
Use an SD memory card that complies with the specifications. (See page 28.)
Verify that the specified audio file or folder exists in the SD memory card. There
must be at least one playable audio file in the specified folder.
Initialize the memory of the device. If this does not solve the problem, contact your
Yamaha dealer.
Specify a preset that exists. No sound will be output unless an appropriate preset
is recalled.
• The Preset selected for recall cannot be recalled as no data has been stored to it.
• Another device may have been added after presets were stored. Please synchro-
nize and check all presets using MTX-MRX Editor, edit as necessary and store
again.
Check the GPI IN settings and perform synchronization again.
Check the GPI OUT settings and perform synchronization again.
Check the DCP[*] settings and perform synchronization again.
Check the Wireless DCP settings and perform synchronization again.
Perform synchronization again using MTX-MRX Editor. If this does not solve the
problem, initialize the memory of the device and synchronize again. If this also
fails, contact your Yamaha dealer.
Do not change any UNIT ID's after performing synchronization. If you've changed
any UNIT ID's, perform synchronization again.
If you have Dante Device Lock enabled, please disable using Dante Controller,
review device DIP switch settings and MTX-MRX Editor's Dante settings, and edit
as necessary to match the current situation.
Response
MRX7-D Owner's Manual
Appendix
27