Switching On The Device - Siemens SIMATIC RF310M Operating Instructions Manual

Simatic sensors rfid systems mobile reader

Hide thumbs Also See for SIMATIC RF310M:

Table of Contents

Commissioning

4.2 Switching on the device

4.2

Switching on the device

Requirements for startup

● The Mobile Reader SIMATIC RF310M is ready-mounted

● The unit's battery is charged (see Charging function (Page 14)).

Note

Before switching the device on for the first time, you must insert the Mobile Reader into

the charging cradle and charge it for approximately 5 hours.

Switching on the device

To switch the Mobile Reader on, press and hold the red "ENTER ON" button for at least one

second.

Figure 4-1

After switching on, the first power-up lasts a few seconds. The RF310M application launches

automatically.

Switching the device off

To switch the SIMATIC RF310M Mobile Reader off, press the blue key and then the

<ENTER ON> key.

Automatic shutdown of the device

The device shuts down automatically if no key is pressed for 5 minutes. After switching on

again, the Mobile Reader continues to operate with the same interface it was using before it

was manually or automatically switched off.