Table of Contents
Advertisement
Quick Links
TimeCutter
For All TimeCutter
Note:
Determine the left and right sides of the machine from the normal operating position.
This product contains a chemical or chemicals known to the State of California
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
SW Riding Mowers
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
Description
No parts required
Rear hitch
Bolt (5/16 x 1 inch)
Locknut (5/16 inch)
Steering wheel
Top cover
Locknut
Rear cover
Screws
Shoulder bolt (seats without a detached
cushion only)
Seat (seats without a detached cushion
only)
Hex bolt
Washer
Seat pan
Seat assembly (seats with a detached
cushion only)
Bottom cushion (seats with a detached
cushion only)
Flange-hex bolt (seats with a detached
cushion only)
Seat assembly
Seat rod
Hairpin cotters
Spacers (certain models only)
Grass deflector (if not installed)
Register at www.Toro.com.
®
SW Riding Mowers
WARNING
CALIFORNIA
Qty.
–
1
2
2
1
1
1
1
2
2
1
2
2
1
1
1
2
1
1
2
2
1
Form No. 3415-319 Rev A
Setup Instructions
Use
Connect the battery.
Install the rear hitch.
Install the steering wheel.
Install the seat to the seat pan (machines
shipped in a steel crate only).
Install the seat assembly.
Install the grass deflector.
Original Instructions (EN)
All Rights Reserved *3415-319* A
Printed in the USA
Advertisement
Table of Contents
Related Manuals for Toro TimeCutter SW series
Summary of Contents for Toro TimeCutter SW series
-
Page 1: Loose Parts
Install the seat assembly. Hairpin cotters Spacers (certain models only) Grass deflector (if not installed) Install the grass deflector. © 2017—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3415-319* A 8111 Lyndale Avenue South Printed in the USA... -
Page 2: Connecting The Battery
– No parts required Check the mower adjustment. Ignition key Hose coupling (not included with CE models) Operator's Manual Complete the setup. Engine Owner’s Manual (non-Toro engines) KeyChoice® key (blue) Connecting the Battery No Parts Required Procedure WARNING CALIFORNIA Proposition 65 Warning... -
Page 3: Installing The Steering Wheel
Installing the Rear Hitch Installing the Steering Wheel Parts needed for this procedure: Rear hitch Parts needed for this procedure: Bolt (5/16 x 1 inch) Steering wheel Locknut (5/16 inch) Top cover Locknut Procedure Rear cover 1. Install the bracket to the frame as shown in Screws Figure 2. - Page 4 Installing the Seat to the Seat Pan Machines Shipped in a Steel Crate Only Parts needed for this procedure: g027737 Shoulder bolt (seats without a detached cushion only) Figure 4 Seat (seats without a detached cushion only) 1. Steering-wheel cover 4.
-
Page 5: Installing The Seat Assembly
B. Place the seat onto the seat pan, aligning the attached seat bolts with the front keyholes, and slide the seat back. C. Secure the seat to the seat pan using 2 hex Installing the Seat bolts and 2 washers (Figure Assembly Parts needed for this procedure:... -
Page 6: Installing The Grass Deflector
Installing the Grass Deflector Parts needed for this procedure: Grass deflector (if not installed) Procedure g027695 g027695 If the grass deflector is not installed, remove it from Figure 9 the packaging and install it onto the mower deck. Refer to your Operator’s Manual for the correct procedure to install the grass deflector. -
Page 7: Completing The Setup
Completing the Setup Parts needed for this procedure: Ignition key Hose coupling (not included with CE models) Operator's Manual Engine Owner’s Manual (non-Toro engines) KeyChoice ® key (blue) Procedure Checking the Tire Pressure Check the front and rear tires for proper inflation;...