Download
Share
Print this page
Toro TimeCutter Series Setup Instructions
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. TimeCutter Series
  6. Setup instructions
Toro TimeCutter Series Setup Instructions

Toro TimeCutter Series Setup Instructions

Hide thumbs
1
2
3
4

Advertisement

Quick Links

Download this manual
TimeCutter
For All TimeCutter
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Note:
Determine the left and right sides of the machine from the normal operating position.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Riding Mowers
Description
Back cushion
Flanged-hex bolt
No parts required
Rear hitch
Bolt (5/16 x 1 inch)
Locknut (5/16 inch)
No parts required
No parts required
Ignition key
Hose coupling (not included with CE
models)
Operator's Manual
Engine owner's manual (non-Toro
engines)
Operator training material
Register at www.Toro.com.
®
Riding Mowers
Qty.
1
3
–
1
2
2
–
–
1
1
1
1
1
Form No. 3415-318 Rev A
Use
Install the back cushion (machines with
a 60-inch deck shipped in a steel crate
only).
Connect the battery.
Install the rear hitch.
Set up the motion-control levers.
Check the mower adjustment.
Completing the setup.
Original Instructions (EN)
All Rights Reserved *3415-318* A
Printed in the USA

Advertisement

loading

Related Manuals for Toro TimeCutter Series

Summary of Contents for Toro TimeCutter Series

  • Page 1 Ignition key Hose coupling (not included with CE models) Operator's Manual Completing the setup. Engine owner’s manual (non-Toro engines) Operator training material Note: Determine the left and right sides of the machine from the normal operating position. © 2017—The Toro® Company Register at www.Toro.com.

  • Page 2: Connecting The Battery

    Installing the Back Cushion Connecting the Battery Machines with a 60-Inch Deck No Parts Required Shipped in a Steel Crate Only Procedure Parts needed for this procedure: WARNING Back cushion Flanged-hex bolt CALIFORNIA Proposition 65 Warning Battery posts, terminals, and related Procedure accessories contain lead and lead 1.
  • Page 3 Installing the Rear Hitch Setting Up the Motion-Control Levers Parts needed for this procedure: Rear hitch No Parts Required Bolt (5/16 x 1 inch) Procedure Locknut (5/16 inch) 1. Locate the motion-control levers attached, but folded down on the machine. Procedure 2.

  • Page 4: Completing The Setup

    Parts needed for this procedure: Ignition key Hose coupling (not included with CE models) Operator's Manual Engine owner’s manual (non-Toro engines) Operator training material Checking the Tire Pressure Remove the packing restraint holding the side discharge chute up and lower the chute into place.