Toro timecutter series Setup Instructions
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. timecutter series
  6. Setup instructions
Toro timecutter series Setup Instructions

Toro timecutter series Setup Instructions

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
TimeCutter® Riding Mower
Model No. All models

Loose Parts

Use the chart below to verify that all parts have been shipped.
Step
1
No parts required
Bolt (1/4 x 3/4 inch)
2
Washer
Nut (1/4 inch)
Seat
Spacers
3
Flat washers
Knobs
Control lever
4
Bolt (1/4 x 3/4 inch)
Ignition Key
Operator's Manual
5
Engine Operator's Manual
Hose coupling
Operator Training Material
Note: Determine the left and right sides of the
machine from the normal operating position.
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Register at www.Toro.com.
Form No. 3356-867 Rev A

Setup Instructions

Qty.
–
Charge the battery.
2
2
Connect the battery.
2
1
2
Install the seat.
2
2
2
Install the motion control levers.
4
1
1
1
Complete thesetup.
1
1
Original Instructions (EN)
Use
Printed in the USA.
All Rights Reserved

Advertisement

Table of Contents
loading

Related Manuals for Toro timecutter series

Summary of Contents for Toro timecutter series

  • Page 1: Setup Instructions

    Operator Training Material Note: Determine the left and right sides of the machine from the normal operating position. Register at www.Toro.com. Original Instructions (EN) © 2006—The Toro® Company Printed in the USA. 8111 Lyndale Avenue South All Rights Reserved Bloomington, MN 55420...

  • Page 2: Charging The Battery

    Step Charging the Battery Figure 1 No Parts Required 1. Vent caps 3. Lower line 2. Upper line Procedure 4. Wait five to ten minutes after filling the Warning battery cells. Add electrolyte, if necessary, until the electrolyte level is up to the Upper line CALIFORNIA (Figure 1) on the battery case.

  • Page 3: Connecting The Battery

    Step Connecting the Battery Parts needed for this step: Figure 4 Bolt (1/4 x 3/4 inch) Washer Nut (1/4 inch) Step Procedure 1. Install the battery in the machine and connect the battery cables using two bolts (1/4 x 3/4 inch), two washers, and two nuts (1/4 inch).

  • Page 4: Installing The Motion Control Levers

    Step 3. Secure the seat to the seat support with the spacers, flat washers (5/16 inch) and knobs (Figure 6). Installing the Motion Control Levers Parts needed for this step: Control lever Bolt (1/4 x 3/4 inch) Procedure 1. Remove the motion control levers from the Figure 6 machine.

  • Page 5: Completing The Setup

    Step Completing the Setup Parts needed for this step: Ignition Key Operator’s Manual Engine Operator’s Manual Hose coupling Operator Training Material Procedure Checking the Tire Pressure Check the front and rear tires for proper inflation. Refer to Checking the Tire Pressure in the Operator’s Manual for the recommended inflation pressure.

Table of Contents