Messages; Weather Timer - Husqvarna AUTOMOWER 440 Operator's Manual

that the PIN code must be entered to prevent triggering
the alarm. The alarm can be turned off at any time by
entering the correct PIN code.
3.14.2 Advanced
Advanced New loop signal
Change PIN code
Duration
3.14.2.1 New loop signal
The loop signal is randomly selected to create a unique
link between the robotic lawnmower and the charging
station. In rare cases, there may be a need to generate
a new signal, for instance if two adjacent installations
have a very similar signal.
1. Place the robotic lawnmower in the charging station.
New loop signal in the menu.
2. Select
3. Press OK and await confirmation that the loop signal
has been generated. This normally takes about 10
seconds.
3.14.2.2 Change PIN code
Enter the new PIN code and press OK. Confirm by
entering the same code again and pressing OK. When
the PIN code is changed, the message
changed appears in the display.
Make a note of the new PIN code on the designated line
Memo on page 3 .
in Memo. See
3.14.2.3 Duration
Duration Duration of alarm
Duration of time lock
Duration of alarm
When Alarm is activated ( High security) there is also the
possibility to select how long the alarm signal should
last. A figure between 1 and 20 minutes can be
selected.
Duration of time lock
A time lock can be set to decide how many days will
pass before the PIN must be entered before use. 1-90
days can be selected.

3.15 Messages

In this menu the previous fault and information
messages can be found. For some of the most common
fault messages, there are tips and advice to help you
rectify the fault.
447 - 001 -
3.15.1 Fault messages
If the robotic lawnmower is disrupted in any way e.g.
gets stuck under a fallen branch a message is shown in
the lawnmower's display relating to the disruption and
the time it happened.
If the same fault message is repeated several times, this
may indicate that an adjustment to the installation or the
robotic lawnmower is required. See
page 49 for more information on possible reasons for
each message.
The list contains the latest 50 fault messages sorted by
date with the last incident to occur first on the list.
The date and time when the fault messages are
displayed can be shown by selecting a fault message
and pressing the OK button.
Tips and advice to help you rectify the fault, are also
displayed.
PIN code
3.15.2 Info messages
Messages shown in the display not caused by an actual
fault are instead saved under the
heading. Examples for such messages is
steep . See Information messages on page 52 for more
information on possible reasons for each message.
The list contains the latest 50 fault messages sorted by
date with the latest incident to occur first on the list.

3.16 Weather timer

The weather timer allows the robotic lawnmower to
automatically adjust its mowing times based on how
quick the lawn grows.
When the weather timer is activated, the robotic
lawnmower needs time to decide what the optimal
mowing time is for the working area in question. For this
reason it can take a couple of days before the mowing
results are optimal.
The robotic lawnmower can not operate longer than the
timer settings. For optimal weather timer performance, it
is therefore recommended when setting the timer to only
de-select the times when the robotic lawnmower must
not operate. Other times should be made available for
the weather timer.
MESSAGES
Fault messages
Info messages
Fault messages on
Info messages
WEATHER TIMER
Use Weather timer
Slope too
Installation - 27