Husqvarna AUTOMOWER 440 Operator's Manual page 53

Message Cause
Guide 1 not found
The guide wire is not connected to the charg-
ing station.
Guide 2 not found
Guide 3 not found
Break in the guide wire.
The guide wire is not connected to the boun-
dary loop.
Guide calibration
The robotic lawnmower has failed to calibrate
failed
the guide wire.
Guide calibration ac- The robotic lawnmower has succeeded to
complished
calibrate the guide wire.
GPS navigation prob-
Not applicable for Automower 420/440. Prob-
lem
lem with the GPS assisted navigation equip-
ment.
Weak GPS signal
Not applicable for Automower 420/440. The
GPS signal is weak for the current working
area. GPS assisted navigation cannot be
used.
Difficult finding home
The robotic lawnmower has been following
the boundary wire several laps without finding
the charging station.
Temporary problem
Please try again.
with the server.
Connection problems Problem with the Automower
ule
Connection settings Settings for wireless connectivity have been
restored
restored due to an error.
Weak signal
Weak GPRS signal for Automower
module
SIM card requires PIN The SIM card must be unlocked.
SIM card locked
The SIM card must be replaced.
SIM card not found
Automower
be inserted in the mower.
Geofence problem
Your Geofence is not working due to poor (or
no) communication with GPS system.
447 - 001 -
®
Connect mod-
®
®
Connect requires a SIM card to
Action
Check that the guide wire's connector is tight-
ly connected to the charging station. See
ing and connecting the guide wire on page
20 .
Find out where the break is. Replace the
damaged section of the guide wire with a new
loop wire and splice using an original coupler.
Check that the guide wire is connected cor-
rectly to the boundary loop. See
connecting the guide wire on page 20 .
Check that the guide wires are installed ac-
cording to the instructions, See
the guide wire on page 19 .
No action required.
Contact your local Husqvarna representative
if this message appears often.
If the message appears often, turn off the
GPS assisted navigation and instead use the
manual settings for Lawn coverage, see
1-5 on page 28 .
The installation has not been done correctly.
Laying the boundary wire on page 18 .
See
Wrong corridor width setting on boundary
.
wire. See
The mower was started on a Secondary area
with the Main area setting.
In case of persisting problems, get in touch
with your local Husqvarna representative.
Restart the mower. If the fault persists, action
by an authorized service technician will be re-
quired.
Check and revise settings if necessary.
Connect Make sure the mower is not upside down. If
the problem persists, action by and author-
ized service technician will be required.
Make sure the correct SIM PIN has been en-
tered into the mower's menu (Network > SIM
card). In case of persisting problems, get in
touch with your local Husqvarna representa-
tive.
Contact the local Husqvarna representative.
Contact your local Husqvarna representative
for more information.
Contact the local Husqvarna representative.
Lay-
Laying and
Installation of
Area
Troubleshooting - 53