Serial Control Specifications; Connection To A Computer; Lan Interface Specifications; Control Specifications - Pioneer HD-V9000 Operating Instructions Manual

(d) Playback status output
This unit's operating status (playing/stopped) can be
detected with the interface connector's STOP_ST pin.
There are two output modes, settable by command.
(1) Stop status detection mode
When in stop mode  "L" is output
When in any other mode  "H" is output
(2) Play status detection mode (default)
When in play mode  "L" is output
When in any other mode  "H" is output
The output is of the open collector type, so pull the voltage
up to a maximum of 12 V (50 mA).

Serial control specifications

(1) Signal level
RS-232C level
(2) Data format
Data length: 8 bits
Stop bits: 1 bit
Parity: None
(3) Communications speed (baud rate)
The communications speed (baud rate) can be selected
from among 2400, 4800, 9600 or 19200 bps. Upon
purchase it is set to 9600 bps (page 47).

Connection to a computer

This unit communicates with the computer using pins 2
and 3 of the 9- or 15-pin D-Sub connector for signal
transfer. Pin 5 of the 9-pin connector or pin 1 of the 15-pin
connector is used as the ground.
The computer and set are connected as shown on the
diagram below.
Computer
TxD
RxD
GND
This unit can accept commands whenever the power is
on. In addition, it can receive the Power On command
even when the power is off (in the standby mode).
There is no need to connect control lines other than TxD
and RxD.
LAN interface
specifications
This unit is equipped with a LAN terminal. It can also be
controlled via LAN cable.
The connector's pin layout is as shown below.
Modular jack (conforming to RJ-45 standards)
Pin No.
1
2
3
4
5
6
7
8

Control specifications

TD+, TD–, RD+, RD–
Ethernet interface conforming to 10BASE-T and
100BASE-TX standards.
(1) Control by same commands as for serial control
See Commands and statuses on page 66.
(2) Wake Up On LAN (remote power control)
(page 70)
HD-V9000
RxD
TxD
GND
Pin Name Input/Output
TD+ Output
TD– Output
RD+ Input
NC
NC
RD– Input
NC
NC
09
Function
LAN line TX+
LAN line TX–
LAN line RX+
LAN line RX–
65
En