Analogue Extensions - NEC SL2100 Quick Install Manual

Configure the SL2100

Analogue Extensions

Timers for analogue extensions are setup in Easy Edit-Extensions-Extension-Single Line Tele[hone SLT-SLT
Data Setup
The following timers are available.
These are not timers and should be set as follows:

Companding Method Type - Select the codec type for the SLT - A law or u-law
Set this to A-Law

Ringing Frequency - Select the ringing frequency, 25Hz, 20Hz or 16Hz.
Set this to 25Hz
Calculating the timer setting
Description
Minimum Break Time
Maximum Break Time
Minimum Make Time
Maximum Make Time
Minimum Hook Flash Time
Maximum Hook Flash Time
Minimum Ground-flash Time
Minimum Off-hook Time
No Detection Time after Off-hook
No Detection Time after Pulse Dial Detection
Loop Disconnect Time after Reversal Time
Ring Message Wait Period
Quick Install Guide – SL2100 Terminals Type B rev 1.0
Setting Timer setting
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 5~1275mS [5mS increment]
1~255 10~2550mS [10mS increment]
1~255 5~1275mS [5mS increment]
21