Flex-Bay Bracket - Lenovo 30BA User Manual

8. Slide the new 2.5-inch storage drive with bracket into the kit from the rear until the drive snaps into
position.
Figure 52. Installing the new 2.5-inch storage drive with bracket into the kit
9. Pivot the rear cover of the kit inward until you hear a click. Ensure that the rear cover is secured in place.
Figure 53. Pivoting the rear cover inward
10. Slide the kit into the flex bay and reconnect the cables.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 145.

Flex-bay bracket

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
To remove or install the flex-bay bracket, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 63.
2. Remove the device that is installed in the flex-bay bracket. See "Device in the flex bay" on page 65.
.
Chapter 7 Hardware removal and installation
85