Philips City Line Helsinki FC8408 Service Manual

Philips Domestic Appliances and Personal Care
Service Manual
PRODUCT INFORMATION
- Electronic controled motor rpm
- Cordwinder build-in with flat cord
- Dustbag-full indicator in dustcover
- This product meets the requirements regarding
interference suppression on radio and TV.
- After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.
TECHNICAL INFORMATION
- Maximum air displacement
- Maximum vacuum water column
- Power consumptio (IEC) 225V
- Dust storage capacity
- Cord length (depends on version)
- Filter system
- Dimensions cleaner
- Weight + accessoiries on board
- Noise
- Colour
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- To open the appliance, first remove the screws A,B,C,D.
- To reach the motor remove the screws E.
- To disassemble the cordwider use Torx screw driver no T10,
which is one of set consisting of :
T20, T15, T10, T9, T8, T7 and T6 = 4822 395 50145.
Published by Philips Domestic Appliances and Personal Care
02/12
City Line Helsinki
- First remove the two screws
B
window. Remove (item 15)
hinge turn + window from (item
3) upper housing by means of a
flat instrument (e.g. screw driver)
as shown (to prevent demage).
The hinge turn + window has
snaps which fits into the upper
housing. Vario / knob turn
(item 10 ) can now be separated
as shown in next drawing.
- Place the knob turn in line with
the adjuster item 10A. Hook
: 34 l/sec
(item 15) hinge turn + window
into the (item 3) upper housing.
: 280 cm
Use the 2 screws (item B) to
: 1400 W
fasten item 15 to item 3. Place
: 2 litres
the cover of vario / knob turn
: 6 m
(item 10) in the correct way;
only on one way possible.
: 6 filters
: 37 x 28 x 23 cm
REPAIR INSTRUCTION
: 4.3 kg
: 80 dB - Give attention that the contact fingers (item 45) are placed on
the cord-winder shaft in such a way that the pressure point of the
: Icicle gold
cordwinder knob to the cord winderlever (item 40) is vertical.
- The spare parts have been standardized as much as possible.
- Component configuration on exploded view may differ in case of
specific versions, however, the actual components are distinguished
by means of code numbers.
- Item 1 Cotton dustbag is used in those countries where paper
dustbags are not available
- Item 41 Cord-winder spring unit is provided with a long spring,
both long and short cords can be used in combination with this
spring.
- Cordwinder spring has to be tensioned till maximum minus
approx. 1,5 revolution.
Printed in the Netherlands
Vacuum cleaner
of (item 15) hinge turn +
© Copyright reserved
FC8408
1
B
B
2
4
B
3
B
2
1
Subject to modification