Table of Contents
Advertisement
Battery Installation for the Remote Control
1.
Slide the back cover up to open the battery
compartment of the remote control.
2.
Insert two AAA size batteries (supplied).
Install the batteries correctly by following the polarity
(+ and -) indications in the battery compartment.
3.
Close the battery compartment cover.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Handling the Batteries
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which
could cause fire, personal injury or damage to property.
• When the batteries are exhausted, the remote will not function. Replace both batteries at
the same time with new ones.
• Only use the battery type indicated in this manual.
• Do not install new batteries with used one and do not mix different types of batteries.
• Do not dispose of used batteries as domestic waste. Dispose of them in accordance with
local regulations.
Handling the Remote Control
• Take care of your fingernails when you press and hold the battery release tab.
• To avoid possible failure, read the following instructions and handle the remote control
properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the batteries from the remote control when not in use for a long period of time,
as it could cause corrosion or battery leakage and may result in physical injury and/or
property damage including fire.
GB
13
Advertisement
Table of Contents
