Customising The Audio Setup; Night Mode; Channel Delay (Centre Delay/ Rear Delay); Test Tone - Hitachi HTD-K200E Instruction Manual

Customising the Audio Setup

1. Press the SETUP button on the remote
control to display the Setup menu.
2. Press the buttons on the remote
control to select Audio Setup to display
the Audio Setup menu.
3. Press the buttons on the remote
control to select Night Mode / Center
Delay / Rear Delay / Test Tone and then
press the OK button.
4. Press the buttons on the remote
control to select an option and then press
the OK button to confirm.
Press the SETUP button on the remote control to exit the menu.
5.

Night Mode

You can use this function to control the different sound levels (Quiet / Moderate / Off)
via dynamic compression. It improves the quality of the sound track at a low volume, and
quietens the loudest sounds.

Channel Delay (Centre Delay/ Rear Delay)

Basic settings have been preset for the speakers included with your unit. However, to suit
the acoustic conditions in your listening room and to make the sound more effective,
you may need to delay the signal coming from some of the speakers. Channel delay
compensates for centre or surround speakers that are closer to the listening position than
the front speakers.

Test Tone

This function is used to test and adjust the volume level (gain) for each individual speaker
channel. Use the buttons on the remote control to select the speaker channel you wish
to test and adjust.
You'll hear a test tone coming from the speaker you select. Use the VOL+ / – buttons on
the remote control to adjust the level to your desired setting. Press the OK button on the
remote control to exit this function.
Audio Setup
Night Mode
Center Delay
Rear Delay
Test Tone
GB
35