Table of Contents
Advertisement
REGULATORY INFORMATION
Federal Communications Commission Interference Statement
The equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment dose cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example – use only shielded
interface cables when connecting to computer or peripheral devices). Any changes
or modification not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 2.5 cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
EUROPEAN COMMUNITY CE NOTICE
Marking by the symbol CE indicates compliance of this equipment to the
R&TTE Directive 1999/5/CE. Such marking is indicative that this equipment
meets or exceeds the following technical standards:
•
EN 300 328
•
EN 301 489 -1, EN 301 489 -17
•
EN 60950
LICENSED SOFTWARE
© Copyright 2000 – 2002, WIDCOMM, Inc. ("WIDCOMM"). All rights reserved.
WARNING: This software and accompanying documentation are protected by copyright law
and international treaties. Unauthorized reproduction or distribution of this software, or any
portion of it, may result in severe civil and criminal penalties, and will be prosecuted to the
maximum extent possible under the law.
Use of this software is governed by the terms of the end user license agreement that accompanies
or is included with such software. Unless otherwise noted in the end user license agreement, or
herein, no part of the documentation accompanying this software, whether provided in printed
or electronic form may be reproduced in any form, or stored in a database or retrieval system, or
transmitted in any form or by any means, or used to make any derivative work (such as translation,
transformation, or adaptation) without the express, prior written consent of WIDCOMM.
Registered Trademark(s) ®, Trademark(s)™, and Service Mark(s)
WIDCOMM, and the WIDCOMM logo are trademarks of WIDCOMM, Inc.
Bluetooth and the Bluetooth logos are trademarks of the Bluetooth SIG, Inc., U.S.A. and licensed
to WIDCOMM, Inc.
Compaq and iPAQ are trademarks of Compaq Information Technologies Group, L.P.
Microsoft, Windows, Outlook, ActiveSync, and the Windows CE logo (graphic only) are either
registered trademarks or trademarks of Microsoft Corporation in the United States and/or other
countries.
Other brand and product names may be registered trademarks, service marks, or trademarks of
their respective holders.
4
SM
5
Advertisement
Table of Contents
