Mitsubishi Electric MAC-568 User Manual page 18

Cool if Room Rises Above Set Maximum Temperature
1. Select 'Cool if room rises above set maximum
temperature' under 'Add a rule'
2. Choose what time period you would like the rule to run.
By default it is set at 9pm to 7am. Note that the 7am is the
following day.
3. Set a maximum temperature limit – the heat pump will Select "Add" to add this max.
temp rule to rule set.
automatically turn on if the room temperature goes above the
maximum temperature. By default this is 26°C. You may set
this between 18°C and 38°C.
4. Next, select which days you would like this rule to run. By
default all days are selected.
5. Lastly select 'Add' to add this rule to your rule set.
*Please note, your heat pump/air conditioner must be off for
min./max. rules to apply.
Zone Control
Should your Wi-Fi Control be connected to a compatible
ducted system and zone controller you will have a further
setting.
You can select to change the zone settings with this rule, or
to leave the zones unchanged/what they were previously set
to.
When actioned, Wi-Fi Control will ensure comfort is delivered
only to where it is needed most, closing off/ opening up
zones as required and ensuring energy is not wasted on
vacant area/zones.
Zones now displaying a tick beside them will be opened
(Zones displaying an eye symbol are zones which are not
visible for operation – if one of these zones is selected for this
rule to apply, it will still open and will cause an over-ride and
this zone will be displayed in the heat pump control screen).
Zones will not be changed.
Important
When minimum / maximum temperature rules are set, zones
will remain as per the rule settings.
Open Lounge and Bedroom 1
zone and close off all others.
18 18