Limiting Connections Through The Csc Ssm - Cisco FirePOWER ASA 5500 series Configuration Manual

Chapter 22 Managing AIP SSM and CSC SSM
This access list matches inbound SMTP connections from any external host to any host on the DMZ
network. The policy applied to the outside interface would therefore ensure that incoming SMTP email
would be diverted to the CSC SSM for scanning. It would not match SMTP connections from hosts on
the inside network to the mail server on the DMZ network because those connections never use the
outside interface.
If the web server on the DMZ network receives files uploaded by HTTP from external hosts, you could
add the following ACE to the csc_in access list to use the CSC SSM to protect the web server from
infected files:
access-list csc_in permit tcp any 192.168.20.0 255.255.255.0 eq 80
For a complete example service policy configuration using the access lists in this section, see
Example

Limiting Connections Through the CSC SSM

The adaptive security appliance can prevent the CSC SSM and the destinations of connections it scans
from accepting or even receiving requests for more connections than desired. It can do so for embryonic
connections or fully established connections. Also, you can specify limits for all clients included in a
class-map and per-client limits. The set connection command lets you configure limits for embryonic
connections or fully established connections.
Also, you can specify limits for all clients included in a class-map and per-client limits. The
per-client-embryonic-max and per-client-max parameters limit the maximum number of connections
that individual clients can open. If a client uses more network resources simultaneously than is desired,
you can use these parameters to limit the number of connections that the adaptive security appliance
allows each client.
DoS attacks seek to disrupt networks by overwhelming the capacity of key hosts with connections or
requests for connections. You can use the set connection command to thwart DoS attacks. After you
configure a per-client maximum that can be supported by hosts likely to be attacked, malicious clients
will be unable to overwhelm hosts on protected networks.
Use of the set connection command to protect the CSC SSM and the destinations of connections it scans
is included in the
Diverting Traffic to the CSC SSM
You use MPF commands to configure the adaptive security appliance to divert traffic to the CSC SSM.
Before configuring the adaptive security appliance to do so, read
Framework,"
To identify traffic to divert from the adaptive security appliance to the CSC SSM, perform the following
steps:
Create an access list that matches the traffic you want scanned by the CSC SSM. To do so, use the
Step 1
access-list extended command. Create as many ACEs as needed to match all the traffic. For example, if
you want to specify FTP, HTTP, POP3, and SMTP traffic, you would need four ACEs. For guidance on
identifying the traffic you want to scan, see the
page
Create a class map to identify the traffic that should be diverted to the CSC SSM. Use the class-map
Step 2
command to do so, as follows.
OL-10088-01
22-1.
"Diverting Traffic to the CSC SSM" section on page
which introduces MPF concepts and common commands.
22-9.
Chapter 21, "Using Modular Policy
"Determining What Traffic to Scan" section on
Cisco Security Appliance Command Line Configuration Guide
Managing the CSC SSM
22-11.
22-11