Mitsubishi Electric Mr.Slim PKA-M35HA Service Manual page 38

OPERATION PROCEDURE
3. Removing the indoor controller board and wireless
controller board
(1) Remove the front panel. (Refer to procedure 2.)
(2) Remove the room temp. thermistor TH1. (see Photo 3)
(3) Remove the electrical box covers (screw 4 × 12).
(See Photo 3)
(4) Disconnect the connectors on the indoor controller board.
(5) Remove the switch board cover.
(6) Pull out the indoor controller board toward you, then
disconnect the rest of connectors.
Remove the indoor controller board and switch board.
(7) Remove the holder of wireless controller board.
(8) Disconnect the connector of wireless controller board and
remove the wireless controller board from the holder.
Screw of electrical box
Photo 5
cover (side) & clamp
(45)
Clamp
4. Removing the electrical box
(1) Remove the front panel. (Refer to procedure 2.)
(2) Remove the electrical box covers. (See Photo 3)
(3) Remove the nozzle assembly. (Refer to 5.)
(4) Disconnect the indoor/outdoor connecting wire from termi-
nal block (TB4).
(5) Disconnect the wired remote controller connecting wire
from terminal block (TB5 (KAL model: Optional parts))
(6) Disconnect the connectors on the indoor controller board.
(7) Disconnect the connector for the ground wire. (See Photo 6)
(8) Pull the disconnected lead wire out from the electrical box.
(9) Remove the screw of electrical box. (See Photo 7)
(10) Push up the upper fixture (See Photo 6) catch to remove
the box, then pull the right fixture (See Photo 4) and
remove it from the box fixture.
OCH660
Room temp.
thermistor (TH1)
Electrical box cover (side)
Caution:
In the case that room temp. thermis-
tor is fixed with the screw of electrical
box cover (side), keep 45mm between
the bottom end of clamp and the top of
room temp. thermistor as Photo 5.
PHOTOS
Photo 3
Electrical box cover (top) Electrical box
Screw (side cover)
Screw (top cover)
Nozzle assembly
Switch board cover
Photo 4
Terminal block (TB4)
Terminal block (TB5)
Photo 6
Connector for
ground wire
Photo 7
38
cover (side)
Room temp.
thermistor
(TH1)
Screw
(side
cover)
Holder of wireless
controller board
Indoor controller board (I.B)
Fixture
(right)
Room temp. thermistor (TH1)
Fixture (upper)
Screw (Electrical box)