Mitsubishi Electric Mr.Slim PKA-M35HA Service Manual page 40

Split-type, heat pump air conditioners
Hide thumbs Also See for Mr.Slim PKA-M35HA:
Table of Contents

Advertisement

OPERATION PROCEDURE
9. Removing the heat exchanger
(1) Remove the front panel (Refer to procedure 2.) and the
corner panel at right lower side.
(2) Remove the electrical box (Refer to procedure 4.) and the
nozzle assembly (Refer to procedure 5.).
(3) Remove the motor band.
(4) Remove the pipe thermistors (Refer to procedure 8.).
(5) Disconnect the connector (CN60) on the indoor controller
board and the connector for ground wire. (See Photo 6)
(6) Remove the screws fixing the left side of the heat
exchanger. (See Photo 10)
(7) Remove the heat exchanger.
10. Removing the room temperature thermistor
(1) Remove the front panel (Refer to procedure 2.).
(2) Remove the electrical box cover.
(3) Remove the room temperature thermistor.
(4) Disconnect the connector (CN20) on the indoor controller
board.
NOTE: When room temp. thermistor is replaced, be sure
to use service parts No. R01 N20 202.
Photo 16
OCH660
Room temp. thermistor
(TH1)
Wire clip
Caution:
There is a case that room
temp. thermistor (TH1) is
fixed with electrical box
side cover screw.
40
PHOTOS
Photo 14
Electrical box cover (side)
Electrical box cover (top)
Heat exchanger
Screw (side cover)
Screw (top cover)
Water cover
Switch board cover
Nozzle assembly
Photo 15
Terminal block (TB4)
Terminal block (TB5)
Room temp. thermistor (TH1)
Screw
Holder of wireless
(side
controller board
cover)
Indoor controller board (I.B)
Fixture
(right)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents