Confirmation Messages - Yamaha Rio3224-D2 Owner's Manual

Information Messages
Message
FACTORY INITIALIZE IN PROGRESS
FACTORY INITIALIZE COMPLETED
HA MEMORY INITIALIZE IN PROGRESS
HA MEMORY INITIALIZE COMPLETED
DANTE INTIALIZE IN PROGRESS
DANTE INITIALIZE COMPLETED
FRONT PANEL LOCKED
FRONT PANEL LOCKED.
TO UNLOCK - PRESS ALL BUTTONS FOR 3 SECONDS
FRONT PANEL UNLOCKED

Confirmation Messages

Message
ARE YOU SURE YOU WANT TO INITIALIZE?
- FACTORY PRESET -
ARE YOU SURE YOU WANT TO INITIALIZE?
- HA PARAMETERS -
ARE YOU SURE YOU WANT TO INITIALIZE?
- DANTE SETTINGS -
SYSTEM Messages
Message
NORMAL
DANTE MODULE ERROR!
ILLEGAL MAC ADDRESS!
UNIT FAN HAS
MALFUNCTIONED!
MEMORY ERROR!
VERSION MISMATCH!
DANTE AUDIO RESOURCE
OVERFLOW!
POWER SUPPLY FAILED!
* If the ID is blank, the message is shown. Otherwise, the ID is shown.
ID * Description
Starting up normally
E00-03 An error has occurred in the Dante module.
E00-04 Because the MAC Address setting has been
damaged, communication is not possible.
E00-06 The cooling fan has stopped.
E00-07 Because the internal memory has been lost,
all data was initialized.
E00-10 The combination of this unit's firmware and
the Dante firmware is incorrect.
The combination of this unit's firmware and
the Rio2-native device's firmware is incorrect.
E00-11 The number of Dante flows has exceeded the
limit.
E00-13 The supply of power to either power supply A
or B has been interrupted.
Description
Started initializing to the factory-set state.
Finished initializing to the factory-set state.
Started initializing the HA parameters.
Finished initializing the HA parameters.
Started initializing the Dante settings.
Finished initializing the Dante settings.
Started panel lock.
Panel lock is enabled.
Panel lock was disabled.
Description
Start initializing to the factory-set state?
Start initializing the HA parameters?
Start initializing the Dante settings?
– – –
The device has malfunctioned; please contact
a Yamaha service center.
The device has malfunctioned; please contact
a Yamaha service center.
Check whether a foreign object might be
caught in the fan. If this does not solve the
problem, contact a Yamaha service center.
If you are using the unit with the START UP
MODE parameter set to RESUME, and
power-cycling the unit does not solve the
problem, please contact a Yamaha service
center.
Match them to compatible versions.
Re-configure the Dante audio routing, for
example by eliminating unneeded routings, or
by using multicast rather than unicast to
improve the efficiency.
Check that the power supply cable is
connected. If checking does not resolve the
problem, contact a Yamaha service center.
Messages
Possible Solution
Owner's Manual
27